Installation and User Manual
EtherHaul
1200™
EH-INST-02, Issue 4.0
Page 67
-
Egress Set
– A frame which belongs to a VLAN identified by
vid
can enter the bridge through any port but can only leave
through the ports that are included in the egress set (Host –
management, Eth0 – radio, Eth1 – ODU port 1, Eth2 – ODU
port 2).
-
Untagged Set
– A subset of the egress set. If a port is a member
of the untagged set and a frame leaves the bridge through this
port, the C-Tag is removed (untagged) To leave the VLAN
tagged when transmitted on all ports in the egress set, enter
none
.
-
History
– If you want the ODU to collect statistics for this VLAN,
select
enable
. Otherwise, select
disable
.
5.
Click
Apply
to close the Add VLAN window.
6.
Click
Apply
to implement the changes and close the Bridge screen.
6.3.3
Configuring VLANs Using the CLI
6.3.3.1
Creating and Modifying VLANs
VLAN definitions are stored in a table containing static configuration information for
each VLAN that is configured in the device by local or network management. All VLAN
Table entries are permanent and are restored when the device is reset.
Use the following syntax to create or modify a VLAN:
set vlan <comp-id-list> <vid-list>
[fdb-id <fdb-id>]
[egress <bridge-port-list>]
[untagged <bridge-port-list>]
6.3.3.2
Blocking Specific VLANs
You can block specific VLANs from entering the EtherHaul system by using the
set vlan
command and setting the
egress
attribute to
none
.
