Installation and User Manual
EtherHaul
1200™
Page 138
EH-INST-02, Issue 4.0
3.
If the system reactivates after reset with a software version stored in the
standby flash bank, use the
accept sw
command to make the standby version
the active version. If you do not execute the
accept sw
command before the
accept-timeout-sec period specified in Step
2 ends, the system resets and
wakes up running the software version image stored in the active flash bank.
Effectively, this means that the software version rolls back. Note that such a
rollback also occurs if a reset occurs (for whatever reason) before the
accept sw
command is entered.
9.5
Monitoring CLI Sessions
Use the following command to display active CLI sessions:
show loginsession [{my | all}]
In response, the software displays the following:
Session ID Session Time
xx
dddd:hh:mm:ss
yy
dddd:hh:mm:ss
Where:
xx
or
yy
is a two-digit integer from 00 to 99, and
dddd:hh:mm:ss
– days(0000 – 9999):hours(00 – 24):minutes(00 – 60):seconds(00 – 60)
To display only the CLI session of the user entering the command, use the
show
loginsession my
command.
To display all active CLI session, use the
show loginsession all
command.
Figure
9-7 Login Sessions Screen
9.6
Viewing System Inventory
You can display a system inventory list using the Web EMS or the CLI.
Table
11-2
on page 181 lists and describes the physical inventory attributes.
All of these attributes are read-only.
For a list and description of the system inventory entities and their
relationships, refer to
Physical Inventory Entities
on page 187.
