Installation and User Manual
EtherHaul
1200™
Page 48
EH-INST-02, Issue 4.0
4
Performing Basic Configuration using the CLI
This chapter explains how to perform basic configuration tasks using the CLI.
For instructions how to configure a link using the Web EMS, refer to
Performing Basic Configuration Using the Web EMS
on page 36.
For instructions on performing advanced configuration, such as network
configuration, synchronization, OAM, and other advanced configuration
tasks refer to
Performing Advanced Configuration
on page 78.
This chapter includes the following topics:
Establishing a CLI Session with the ODU
Saving Configuration Changes and Resetting the System Using the CLI
Configuring and Displaying Basic System Information Using the CLI
Configuring System IP Addresses Using the CLI
Configuring Radio Parameters Using the CLI
Configuring Ethernet Interfaces Using the CLI
Default VLAN Setting
Note:
Before you perform basic configuration on the ODU, you must ensure that the ODU
is set to either Adaptive or Static mode. The RF LED color indicator on a network-
ready ODU is
green
. Refer to Step
2 in
Performing Initial System Setup
, on page 35.
4.1
Establishing a CLI Session with the ODU
1.
Run a standard SSH client. You can use a common, open source SSH client
program, such as PuTTY, available for download from the web.
2.
Enter the ODU’s
default
IP address:
192.168.0.1
(the default Mask is
255.255.255.0) and open the connection.
3.
Login as user
admin
.
4.
Enter the password
admin
.
When a successful connection is established, the ODU responds as follows:
login as: admin
EH-1200, S/N: F026500012, Ver: 3.0.0 6311
[email protected]'s password:
