Installation and User Manual
EtherHaul
1200™
Page 96
EH-INST-02, Issue 4.0
set cfm-ma-comp c3 2 2 vlan 200
The following command creates a Maintenance End Point (MEP).
set cfm-mep 2 2 1 interface eth1 dir up cci enabled
The following command creates a Peer MEP.
set cfm-peer-mep-create 2 2 2
The following command sets the MIP to the lower level.
set cfm-ma-comp c3 2 2 vlan 200 mhf-creation explicit
To create MIPs on the radio potr (lower level), you must create the Component MA on
C3 (Up MEP). If the C3 Component MA is not created on C3, the CFM packets will not
enter and pass the through the MIP.
The MHF-Creation value, which determines whether MIPs are created, can be on one of
two settings:
Default
– Creates MIPs on all ports.
Explicit
– Creates MIPS only on ports that have MEPs on their lower level.
Configuring the Remote ODU
The first step in configuring CFM parameters is to enable the OAM license. Without an
enabled OAM license, the necessary CFM commands are not available.
set license oam status enable
The next step in this configuration is to configure an MD at level 0:
set cfm-md 1 name string Link level 0
The following command creates an MA.
set cfm-ma 1 1 name string Link interval 300hz
The following command creates a Component MA and assigns VLAN 200 as its Service
Selector.
set cfm-ma-comp c2 1 1 vlan 200
The following command creates a Maintenance End Point (MEP).
set cfm-mep 1 1 2 interface eth0 dir down cci enabled
The following command creates a Peer MEP.
set cfm-peer-mep-create 1 1 1
The following command creates an MD at level 2.
set cfm-md 2 name string Customer level 2
The following command creates an MA.
set cfm-ma 2 2 name string Customer interval 1s
