Installation and User Manual
EtherHaul
1200™
EH-INST-02, Issue 4.0
Page 95
Figure
7-14 Link Trace Status
7.2.9
Sample CFM Configuration
This section provides a sample CFM configuration script.
Configuring the Local ODU
The first step in configuring CFM parameters is to enable the OAM license, which is part
of the L2 Networking license. Without an enabled OAM license, the necessary CFM
commands are not available.
set license oam status enable
The next step in this configuration is to configure an MD at level 0:
set cfm-md 1 name string Link level 0
The following command creates an MA.
set cfm-ma 1 1 name string Link interval 300hz
The following command creates a Component MA and assigns VLAN 200 as its Service
Selector.
set cfm-ma-comp c2 1 1 vlan 200
The following command creates a Maintenance End Point (MEP).
set cfm-mep 1 1 1 interface eth0 dir down cci enabled
The following command creates a Peer MEP.
set cfm-peer-mep-create 1 1 2
The following command creates an MD at level 2.
set cfm-md 2 name string Customer level 2
The following command creates an MA.
set cfm-ma 2 2 name string Customer interval 1s
The following command creates a Component MA and assigns VLAN 200 as its Service
Selector.
