Installation and User Manual
EtherHaul
1200™
EH-INST-02, Issue 4.0
Page 127
Table
11-24
on page 221 lists and describes the outgoing queue attributes.
8.6.2
Incoming Queues Commands
Currently Incoming Queues are defined only for rf. However, the design should take into
account the possibility that the other interfaces will also have incoming queues and
their statistics may be different from rf.
Use the following command to display statistics for incoming queues:
show in-queue {rf | all} {1..4 | all} statistics
Counters of all incoming queues appear, as follows:
Interface qid
good
error lost
elapsed-time
Note that for
rf
there are only four queues. Therefore, only numbers from 1 to 4 (or
all
) are valid for the second ID. If
all
is specified, only four queues are displayed.
Use the following command to clear the incoming queue statistics:
clear in-queue {rf | all} {1..4 | all} statistics
Table
11-25
on page 221 lists and describes the incoming queue attributes.
8.7
Viewing Ethernet Statistics
You can display statistics on EtherHaul’s Ethernet interfaces using the Web EMS or the
CLI.
8.7.1
Viewing Ethernet Statistics Using the Web EMS
To display Ethernet statistics using the Web EMS, click the icon of the interface for
which you want to view statistics on the EMS Web Main screen (
Figure
3-11
), then click
the Statistics section of the Interfaces screen.
The Statistics section includes the following tabs:
Current
– Real time statistics counters since the last time the Ethernet
statistic counters were cleared.
Figure
8-10 Statistics Screen
– Current Tab
