Siemens SINAMICS S150 NEMA, Руководство по эксплуатации

Страница: 337 / 862

Operation
6.7 Communication according to PROFIdrive
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
335
6.7.4.2 Determining the drive object numbers
Further information about the drive system (e.g., drive object numbers) can be determined
as follows from parameters p0101, r0102 and p0107/r0107:
1.
The value of parameter r0102 ("Number of drive objects") is read via a read request from
drive object 1.
The drive object with drive object number 1 is the Control Unit (CU), which is always
present in every drive system, as a minimum.
2. Depending on the result of the initial read request, further read requests to drive object 1
are used to read the indices of parameter p0101 ("Drive object numbers"), as specified by
parameter r0102.
Example:
If the number of drive objects is "5", the values of indices 0 to 4 of parameter p0101 are
read. The relevant indices can also be read at once.
3. Following this, parameter r0107/p0107 ("Drive object type") is read for each drive object
(indicated by the drive object number).
Depending on the drive object, parameter 107 can be either an adjustable parameter or a
display parameter.
The value in parameter r0107/p0107 indicates the drive object type. The coding for the
drive object type is specified in the parameter list.
6.7.4.3 Example 1: Reading parameters
Preconditions
● The PROFIdrive controller has been commissioned and is fully operational.
● PROFIdrive communication between the controller and the device is operational.
● The controller can read and write data sets in conformance with PROFINET/PROFIBUS.
Task description
Following the occurrence of at least one fault (STW1.3 = "1") at drive 2 (also drive object
number 2), the active fault codes are to be read from the fault buffer r0945[0] ... r0945[7].
The request is to be handled using a request and response data block.
Basic procedure
1. Create a request to read the parameters.
2. Invoke request.
3. Evaluate response.