Siemens SINAMICS S150 NEMA, Руководство по эксплуатации

Страница: 406 / 862

Operation
6.11 Communication via EtherNet/IP
Enclosed Drives
404
Operating Instructions, 12/2018, A5E36652151A
3. Set the subnet mask using p8943.
You can find the currently valid subnet mask in r8953.
4. Set the standard gateway using p8942.
You can find the currently valid standard gateway in r8952.
5. Set the station name using p8940.
You can find the currently valid station name in r8950.
6. Select the setting "Save and activate configuration" as interface configuration using
p8945 = 2.
7. Save the data using command "Copy RAM to ROM".
Then switch off the drive power supply.
8. Carry out a POWER ON (switch off the Control Unit and switch on again).
Wait until all LEDs on the drive are dark before switching on. Your settings become active
after switching on.
6.11.4 Supported objects
Overview
Object class Object name Objects
required
SINAMICS
objects
hex dec
1 hex 1 Identity object x -
4 hex 4 Assembly Object x -
6 hex 6 Connection Management Object x -
32C hex 812 Siemens Drive Object - x
32D hex 813 Siemens Motor Data Object - x
F5 hex 245 TCP/IP Interface Object
1)
x -
F6 hex 246 Ethernet Link Object
1)
x -
300 hex 768 Stack Diagnostic Object - x
302 hex 770 Adapter Diagnostic Object - x
303 hex 771 Explicit Messages Diagnostic Object - x
304 hex 772 Explicit Message Diagnostic List Object - x
401 hex 1025 Parameter object - x
402 hex ...
43E hex
1026 ... 1086 Parameter object - x
1)
These objects are part of the Ethernet/IP system management.
For Assembly Object "4 hex" you define the data length. Assembly Object is assigned a
cycle in the control system.