SV800/SV800A User Manual 5 Introduction of operation and running
57
5.1.2 The setting and debugging check of the frequency inverter
The set of parameters is mainly used to check the setting and debugging of the inverter before
running. Then run the inverter after checking correctly. If any omissions, please follow the
instructions to complete the preparation.
No.
Contents
Remarks
Basic check
□
1
Did you read the manual carefully during
debugging or commissioning?
□
2
Whether confirm the information in the wiring
checking table (5.1.1 Wiring check of the frequency
inverter)?
□
3
Whether the frequency converter is power on?
Nameplate check
□
4
Whether any conflict between the frequency
inverter nameplate and the controlled motor
nameplate?
□
5
Whether the parameters of the motor nameplate
conflict with the input range of the motor parameter
group?
Motor parameters self-learning check
□
6
Whether the controlled motor has design manual? If
so, please input electrical parameters according to
the manual and perform static self-learning?
□
7
Whether the motor is separated from the load before
self-learning?
□
8
Whether the setting of the motor nameplate
parameters are correct? Are the self-learning
preparations finished?
□
9
Whether select the control of the second motor
control? Whether perform self-learning for the
second motor according to the requirement?
□
10
After the motor self-learning finished, please check
whether the motor parameters abnormal or not and
whether any failure occurred about self-learning?
Speed sensorless vector control mode check
□
11
Whether the running direction and speed interval of
the motor correct?
