Schweitzer Engineering SEL-351P, Быстрый старт

Страница: 443 / 674

Date Code 990430 Setting the SEL-351P Recloser Control 9-37
SEL - 351P Manual Técnico
Row
Bit
Definition Primary
Application
BCWA A-phase breaker contact wear has reached 100%
wear level (see
Breaker/Recloser Contact Wear
Monitor in Section 8 )
Indication
BCWB B-phase breaker contact wear has reached 100%
wear level (see
Breaker/Recloser Contact Wear
Monitor in Section 8 )
BCWC C-phase breaker contact wear has reached 100%
wear level (see
Breaker/Recloser Contact Wear
Monitor in Section 8 )
BCBOK Battery charge board is OK (enabled) (see Battery
Sytstem Monitor in Section 8 )
TOSLP Battery capacity has gone below user-set capacity
threshold and recloser control will shut down (go to
sleep) (see
Battery System Monitor in Section 8 )
Indication, event
or SER trigger
DISTST Battery discharge test in progress (see Battery
System Monitor in Section 8 )
Indication
DTFAIL Battery discharge test has failed (see
Battery System
Monitor in Section 8 )
Alarm,
indication
37 ALARM Output contact ALARM asserted (see Figure 7.26)
OUT107 Output contact OUT107 asserted (see Figure 7.26)
OUT106 Output contact OUT106 asserted (see Figure 7.26)
OUT105 Output contact OUT105 asserted (see Figure 7.26)
OUT104 Output contact OUT104 asserted (see Figure 7.26)
OUT103 Output contact OUT103 asserted (see Figure 7.26)
OUT102 Output contact OUT102 asserted (see Figure 7.26)
OUT101 Output contact OUT101 asserted (see Figure 7.26)
38 3PO Three pole open condition (see Figure 5.3) Testing
SOTFE Switch-onto-fault condition (see Figure 5.3)
Z3RB Zone (level) 3 reverse block (see Figure 5.6)
KEY Key permissive trip signal start (see Figure 5.6) Output contact
assignment
EKEY Echo key (see Figure 5.6) Testing
ECTT Echo conversion to trip condition (see Figure 5.6)
WFC Weak infeed condition (see Figure 5.6)
PT Permissive trip signal to POTT logic (see Figure 5.5)