Schweitzer Engineering SEL-351P, Быстрый старт

Страница: 26 / 674

Communications
20 SEL-351P Quick-Start Installation and User's Guide (Portuguese)
Access Level
and
Available
Commands Description
Corresponding
Front-Panel
Pushbutton
PAS 2
DISABLE Disables Access Level 2 password.
Note: “DISABLE” must be entered in uppercase.
SET n Change relay settings (overcurrent, reclosing, timers, etc.) for Group n. AJUSTE
SET L n Change SEL
OGIC
Control Equation settings for Group n.
SET EZ n Change EZ settings for Group n. AJUSTE
SET FZ Change FZ settings (global EZ settings). AJUSTE
SET G Change global settings. AJUSTE
SET P n Change port n settings. AJUSTE
SET R Change Sequential Events Recorder (SER) settings.
SET T Change text label settings.
VER Show version information.
Event Reports
Event reports are automatically triggered at the beginning of a fault and
when the SEL-351P issues a trip. Event report length is 15 cycles
(factory default). The latest twenty-eight 15-cycle event reports are
stored in nonvolatile memory.
To obtain event report information use the EVE command. There are
numerous options that allow you to customize event information. For
descriptions and examples of all options, refer to the
SEL-351P Manual
Técnico . The general command format is:
EVE [ n A D ]
The parameters in brackets [ ] are optional. The following table defines
the parameters [
n A D ] that can be issued with the EVE command to
customize the report format.
Note:
The event report length is
selectable: 15 or 30 cycles.
More options are available to
customize event reports.
Refer to
Section 12 in the
SEL-351P Manual Técnico for
more event information.