Remote Commands
R&S
®
Spectrum Rider FPH
364
User Manual 1321.1011.02 ─ 06.00
Example:
CALC:MARK:FUNC:ADEM:FERR?
Reads out the Carrier Offset value for both AM/FM.
Usage:
Query only
CALCulate<1...2>:MARKer:FUNCtion:ADEMod:MINDex[:RESult]?
This command displays the Modulation Index value for AM.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Example:
CALC:MARK:FUNC:ADEM:MIND?
Reads out the Modulation Index value for AM.
Usage:
Query only
13.6.4
Remote Commands of the Power Meter
The chapter provides information on remote commands that configure and perform
power measurements with the power sensor. These commands are available in power
meter mode only.
Availability of remote commands for Power Sensor measurements
Note that the listed remote commands take effect only if a power sensor is connected.
Contents
●
Chapter 13.6.4.1, "Setting the Frequency"
●
Chapter 13.6.4.2, "Configuring Power Level Readout"
●
Chapter 13.6.4.3, "Defining the Measurement Time"
●
Chapter 13.6.4.4, "Zeroing of the Power Sensor"
●
Chapter 13.6.4.5, "Forward Power Display"
●
Chapter 13.6.4.6, "Defining the Video Bandwidth"
●
Chapter 13.6.4.7, "Reading Out Measurement Results"
●
Chapter 13.6.4.8, "Selecting a Telecommunication Standard"
13.6.4.1
Setting the Frequency
The following chapter describes commands necessary to define frequency settings.
List of commands
●
●
CALCulate<1...2>:PMETer:CPOWer:BANDwidth
Remote Control - Commands