Rohde & Schwarz R&S FPH, Руководство пользователя

Страница: 115 / 484

Working with the Measurement Wizard
R&S ® Spectrum Rider FPH
110 User Manual 1321.1011.02 ─ 06.00
Figure 5-2: Measurement setting dialog
Table 5-1: Measurement setting parameters
Measurement parameters Descriptions
General User Name of the person that performs the measurement.
Measurement
Definition
Name of the measurement wizard set. This field is a read-
only field that shows the measurement name as defined in
the R&S InstrumentView software package.
Number of
Steps to Per-
form
Number of individual measurements in the measurement
sequence as defined with the R&S InstrumentView soft-
ware package.
The field allows you to reduce the number of individual
measurements and perform only those measurements that
are necessary. If you reduce the number of measurements,
the R&S Spectrum Rider omits the last measurement in the
sequence.
You can edit this field only if you turned on the "Allow Vari-
able Number of Sequence Steps" in the "Wizard Set Editor"
of the R&S InstrumentView software.
Descriptions Short description of the measurement task. This field is a
read-only field that shows the description as defined with
the R&S InstrumentView software.
Site Site Name Location of the measurement.
Comments Comments about the measurement, e.g. the external con-
ditions during the measurement.
GPS Position Displays the GPS information. See Chapter 3.2.7.3, "Using
the GPS Receiver" , on page 57.
Measurement specification
The measurement specification dialog box displays the measurement step sequences
and the individual performed measurement status. See Figure 5-3 .
Performing and Configuring Measurements