Working with the Measurement Wizard
R&S
®
Spectrum Rider FPH
113
User Manual 1321.1011.02 ─ 06.00
The R&S Spectrum Rider prompts you to save measurement result and
exit the wizard measurement.
● Select the "Interrupt" softkey.
The R&S Spectrum Rider opens the wizard interrupt dialog box.
There are three selections in the wizard interrupt dialog box, you can either:
– Select the "Leave Menu" softkey to proceed and perform the necessary
reconfiguring of the measurement. The R&S Spectrum Rider goes to the
current measurement environment which you can analyze the measure-
ment settings and make the necessary reconfiguration on the measure-
ments.
After you have completed the reconfiguration on the measurement, press
[WIZARD] key to return back to the wizard interrupt dialog box
– Select the "Resume Sequence" softkey to resume back to the measure-
ment.
– Select the "Cancel" softkey to abort the wizard measurement.
● Select the "Skip" softkey.
The R&S Spectrum Rider skips a single measurement step and continue the
subsequent measurement step.
Note: Alternatively, you can swipe horizontally to the left direction to skip a wiz-
ard measurement. See
Chapter 4.2.9, "Skip Wizard Measurement"
● Select the "Cancel" softkey.
The R&S Spectrum Rider displays a message "Cancel Incomplete Wizard
Sequence" in the wizard message box.
Select "YES" to abort the wizard measurement or "NO" to continue.
This is followed with a message prompt to save measurement result. The R&S
Spectrum Rider displays a message "Save Wizard Measurement Results" in
the wizard message box.
Select "Save Result" to save the measurement results or "Discard Result" to
discard the measurement results.
3. After each measurement is completed, the R&S Spectrum Rider displays a mes-
sage "Measurement Done" in the wizard message box.
Select the "Continue" softkey to proceed to the next measurement step (if any).
Performing and Configuring Measurements
