20 • Chapter 2: Description
GX-6000 Operator’s Manual
Included Accessories
Included accessories consist of the tapered rubber nozzle, belt clip, rubber boot, wrist
strap, and the sample hose/probe.
Tapered Rubber Nozzle
A cone shaped 4 inch long rubber nozzle is included with the GX-6000 as standard. It can
be installed on the inlet fitting by pushing the larger end over it. The smaller end can be
inserted through a hole in a wall or some other access to an enclosed area to sample the
environment.
Belt Clip
A belt clip can be mounted to the back of the case using 3 Phillips head screws. The belt
clip allows the GX-6000 to be securely attached to a belt.
Rubber Boot
A protective rubber boot can be installed over the GX-6000.
Wrist Strap
A wrist strap is included with the GX-6000 and can be attached to the right or left wrist
strap installation feature on the GX-6000 case.
Sample Hose and Probe
A 3 foot sample hose with an attached probe is standard with the GX-6000. When desired,
the rubber nozzle may be removed and the sample hose and probe may be connected to the
inlet fitting. Sample hose lengths are available from 3 feet to 50 feet (see “Chapter 7:
General Parts List” on page 128). The quick connect end of the sample hose connects to
the inlet fitting of the GX-6000. The probe is integral with the hose and connects to it with
a tube fitting.
CAUTION:
Sample hose lengths of more than 50 feet are not recommended for the GX-
6000 because of flow rate reduction.
The probe includes a replaceable particle filter and hydrophobic filter disk that prevent
particulates and water from entering the GX-6000’s flow system. See “Replacing the
Probe’s Particle Filter and Hydrophobic Filter Disk” on page 110 for instructions to
replace the particle filter and hydrophobic filter disk.
Figure 2: Sample Hose and Probe