PerkinElmer PINAACLE 900 Series, Руководство по оборудованию и обслуживанию для клиентов

Страница: 124 / 390

108
Installation
Install the spectrometer by following exactly the procedures described in this
chapter, as summarized in the steps below.
1. Prepare the new site for the spectrometer; see Chapter 2, Preparing Your
Laboratory on page 37 .
2. Connect the burner and furnace gas supplies.
3. Connect the drain system to the burner.
4. Install the furnace autosampler.
5. Connect the cooling system for the graphite furnace.
6. Make sure that the main power switches of all the instruments are in the off
position, then connect the electrical cables.
Connecting the Burner Gases
The connectors for the burner gases are located on the rear panel of the
spectrometer.
What you need to provide
• Suitable supplies of acetylene, air, and nitrous oxide. The gases must conform
with the requirements listed in Chapter 2,
Preparing Your Laboratory on page
37 .
• Suitable pressure regulators and on/off valves near to the spectrometer for the
gas supplies.
The gas supply systems must comply with your local safety regulations. Also refer
to the information given under
Gas Requirements on page 52 .
Note
The instrument ships with the nebulizer in place based on the part number
configuration ordered (a stainless steel or high sensitivity corrosion
resistant plastic nebulizer).