PerkinElmer PINAACLE 900 Series, Руководство по оборудованию и обслуживанию для клиентов

Страница: 237 / 390

221
Reassembling the Burner System
3. Remove the nebulizer from the end cap assembly. Refer to Removing the
Stainless Steel Nebulizer on page 231 . Refer to Removing the High Sensitivity
Plastic Nebulizer on page 236
4. Clean the chamber. Place the parts in a detergent solution until they are
completely clean. See Cleaning the Burner Chamber on page 208 for details.
5. Remove and rinse with deionized water. Allow time for complete drying.
Reassembling the Burner System
After you have completed maintenance procedures, reassemble the burner system
as given below.
To reassemble the burner chamber
1. Before you reassemble the burner system, verify that the o-rings are in good
condition. If an o-ring appears damaged, replace it.
2. Connect the drain tube and clamp.
3. Carefully slide the nebulizer into the end cap and lock into place with the
nebulizer clamp.
4. Place the burner o-ring into the burner chamber and screw on the retaining ring.
5. Press the safety latch on the ignitor box while gently pushing and twisting the
burner head onto the chamber.
To Install the Burner in the Spectrometer
1. Guide the burner assembly into the tracks of the Burner Assembly mount.
2. Push the burner assembly in so that the rear gas fittings line up with the gas
connectors at the back of the Burner Assembly mount. Push the burner
assembly fully in until it clicks into place. Pull the locking level forward until
it locks the burner assembly in place. The locking pin automatically locks.