![background image](http://html.mh-extra.com/html/nec/image-p100e-service/image-p100e-service_manual_248524094.webp)
Using the ECU and SCSI Utilities 4-19
PCI IDE controller
If you installed an IDE hard disk in the system, locate the
“Embedded PCI IDE controller” on the system board list of
details and enable “Standard IDE Resources.”
NOTE: Enabling the IDE controller automatically
changes any installed SCSI controller to a secon-
dary controller and might change the IRQ.
If you have an IDE hard disk, you must also run
the Setup utility at power-on to set the drive
parameters.
PCI SCSI controller and SCSI termination
If you have a SCSI device installed in the system, check
that the Embedded PCI SCSI Controller parameter is en-
abled.
If you have both internal and external SCSI devices in-
stalled and connected to the on-board SCSI-2 host adapter,
use the SCSI Select Utility to set “External” SCSI device
termination. Run the SCSI Select Utility when you complete
the system configuration with the ECU (See “SCSI Select
Utility” later in this chapter).
Shadowing and caching features
The shadowing and caching features should be left enabled.
Step 4: Examine Required Switches
Select Step 4 to view any required switch and jumper
settings on installed boards. To view the required settings,
highlight the board you wish to view, and press
Enter.
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...