![background image](http://html.mh-extra.com/html/nec/image-p100e-service/image-p100e-service_manual_248524042.webp)
2-18 Using Your System
■
You cannot exit from an application program. In this
case, first try a software reset in Windows for
Workgroups (see the following instructions for a
software reset).
■
You change the system configuration after editing the
CONFIG.SYS file.
■
You change your system configuration settings or
operating system and you want to start the system with
the new settings.
■
The monitor screen is black. If your screen is black, it
may only need a simple adjustment. Before you reset the
system, check the following:
Adjust the contrast and brightness controls on the
monitor.
Check that your monitor is properly connected and
the monitor power is on.
You can reset the system in two ways:
CAUTION: Unless absolutely necessary, do not
reset the system when the hard disk lamp or
diskette drive busy lamp is on. Information on the
hard disk or diskette might be lost or damaged.
■
With a software reset.
Press and hold
Ctrl
,
Alt
, and
Del
. When all three keys
are pressed, the system resets.
A software reset performs a warm boot. It clears volatile
system memory and reloads the operating system.
■
With a hardware reset.
Press the reset button on the front of the system unit.
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...