Using the ECU and SCSI Utilities 4-1
Using the ECU and
SCSI Utilities
This chapter provides information for the following utilities
that you use when installing, changing, or checking expan-
sion devices in your system:
■
EISA Configuration Utility (ECU)
■
SCSI Utility.
The ECU utility is used to configure your system whenever
you add, move, or remove an optional EISA, PCI, Plug and
Play ISA, or non-Plug and Play ISA expansion device. The
ECU utility comes on a diskette shipped with your system.
NOTE: Do
not copy the EISA Configuration Utility
to your hard disk. The utility program must start with
a
cold boot from the EISA Configuration Utility
diskette.
The SCSI utility is used to check or change the settings of
your installed SCSI-2 devices or to configure your system
for any optional SCSI devices that you may install. The
SCSI utility is pre-installed on your system and ready to
run.
Refer to the following table for a quick reference to
configuring optional expansion devices. For details, see this
chapter and the referenced chapters and sections in the
table.
4
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...