Setting System Parameters 3-1
Setting System
Parameters
This chapter describes the ROM-based Setup utility that
allows you to view and enter system configuration informa-
tion. The Setup utility is pre-installed on your system and
ready to run.
Your system ships with the correct system parameters for
your configuration. Unless you add optional hardware
devices, you do not need to run the Setup utility to operate
your system. However, you might wish to run Setup to set
the time, date, and security features.
NOTE: If you are adding, moving, or removing an
optional EISA, PCI, Plug and Play ISA, non-Plug
and Play ISA, or SCSI expansion device, use the
ECU and SCSI utilities. See Chapter 4, “Using the
ECU and SCSI Utilities,” for information.
Use the Setup utility to:
■
check or change the time and date.
■
check or change the diskette drive type.
■
check or change IDE hard disk parameters.
■
check or change system parameters when you add or
remove PCI devices.
■
check or change your video device.
3
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...