Using the ECU and SCSI Utilities 4-15
9.
When you are done, press
F10
to exit “Step 2: Add or
remove boards” configuration procedure.
Before you exit, note information you might need to
change settings or install boards. To print out any con-
figuration information about the board, select “Step 4:
Examine Required Switches.”
Repeat steps 1 through 9 in the above procedure to add
another board.
Step 3: View or Edit Details
Select Step 3 to modify system board settings or to config-
ure your system when you are setting up for the first time.
System board settings include the following configuration
categories:
■
System and video BIOS caching, and system and video
BIOS shadowing
■
Port configurations — parallel port, serial
port 1, and serial port 2 addresses and interrupts.
■
Peripheral controllers — diskette drive controller, PCI
SCSI controller, PCI IDE controller, PCI VGA
controller.
Refer to the following table for a quick-reference list of
ECU utility parameters and their factory (default) settings.
See the procedure and additional information following the
table to configure your system board.
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...