Adding Options 7-47
■
If you are installing a 1.2-MB diskette drive, connect
the diskette drive signal cable and power cable.
Align the signal cable connector as shown in the fol-
lowing figure.
■
Reconnect the power and signal cables to the CD-
ROM reader.
Connecting 1.2-MB diskette drive cables
9.
Push the device bracket up against the chassis and se-
cure in place with the five previously removed screws.
10.
Install the metal cover plates over any empty slots and
secure with the previously removed screws.
If you installed a hard disk in the 5 1/4-inch slot, install
a metal cover plate over the slot.
11.
Install the slot covers over the empty slots by snapping
them into the slots in the metal cover plates.
If you installed a hard disk in the 5 1/4-inch slot, install
a slot cover over the metal cover plate.
1.2-MB Diskette
Drive Connector
Red Edge
Diskette Drive
Signal Cable
Power Cable
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...