![background image](http://html.mh-extra.com/html/nec/image-p100e-service/image-p100e-service_manual_248524157.webp)
7-32 Adding Options
Use external termination when both internal and external
SCSI devices are installed.
NOTE: In all SCSI configurations (internal and ex-
ternal), a terminated device must be attached to the
end connector on the SCSI cable.
Termination Power
The SCSI controller is factory set to supply termination
power to the SCSI bus. If your SCSI device provides a
setting for termination power, disable the drive power. Set
the termination power supplied by the device to “auto power
sense” or “off.”
Motor Start at Power-On
In multiple SCSI drive configurations, disable the SCSI
drive’s motor start at power-on feature. Set the motor to
start with a Start Unit command from the SCSI controller.
Disabling the motor start at power-on allows the SCSI de-
vices to start up one at a time and prevents a power surge.
SCSI IDs
SCSI identification (ID) numbers configure all SCSI
devices on internal and external SCSI cables with a device
address for the SCSI bus. You can attach up to five internal
devices to the internal SCSI cable.
You can attach up to seven external devices to the SCSI bus
through the SCSI connector on the rear of the system. If in-
stalling both internal and external SCSI devices, you can
attach a total of seven devices.
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...