![background image](http://html.mh-extra.com/html/nec/image-p100e-service/image-p100e-service_manual_248524174.webp)
7-48 Adding Options
12.
Install the front panel to the chassis with the four pre-
viously removed screws (two to a side).
13.
If you installed a 1.2-MB diskette drive, remove the
protective cardboard insert from the drive.
14.
Replace the system unit cover.
Be sure that you do not pinch any cables or wires when
you replace the cover.
15.
Connect external peripherals and power cables.
16.
Run the Setup, ECU, or SCSI utility to set your new
configuration (see Chapter 3 and Chapter 4).
Installing an Internal Storage Device
Use the following procedure to install a device in the 3 1/2-
inch internal device bracket.
NOTE: The internal device bracket holds up to two
1.0-inch high devices or one 1.0-inch high and one
1.6-inch high device.
1.
Follow the pre-installation instructions that come with
your device, such as setting jumpers and switches.
2.
Follow any pre-installation instructions for setting
device parameters. See Chapter 3, “Setting System Pa-
rameters,” and Chapter 4, “Using the ECU and SCSI
Utilities.”
3.
Remove the system unit cover.
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...