![background image](http://html.mh-extra.com/html/nec/image-p100e-service/image-p100e-service_manual_248524166.webp)
7-40 Adding Options
2.
Follow any pre-installation instructions for setting
device parameters. See Chapter 3, “Setting System Pa-
rameters,” and Chapter 4, “Using the ECU and SCSI
Utilities.”
NOTE: If your 5 1/4-inch device comes with drive
rails, do not attach them. Remove any rails already
attached. See the documentation that comes with
the device.
3.
Remove the system unit cover (see “Removing and Re-
placing the System Unit Cover” earlier in this chapter).
WARNING: Be sure that system power is
off and
the system and its peripherals are
unplugged before
you begin the installation procedure.
4.
Remove the device bracket from the system as follows:
■
Remove the four screws (two to a side) holding the
front panel to the system, and remove the panel.
Содержание IMAGE P100E - SERVICE
Страница 162: ...7 36 Adding Options Adding Options 7 ...
Страница 167: ...Adding Options 7 41 Removing the front panel screws Front Panel Screws ...
Страница 229: ...Glossary 11 write protection Allows reading from a diskette but prevents writing to a diskette ...
Страница 234: ...Index 5 Voltage selector switch 2 9 W Warranty B 8 Work environment A 1 A 7 ...