B A C 2 0 9 0
Model Name: Rockhopper-46/62
B A C 2 0 9 0
Model Name: Rockhopper-46/62
Adjustment: CW
Adjustment: CW
Left and right head axial adjustment for normal dots and microdots.
Have the printer print unidirectionally and from the results enter the position error for CW printing (separately for Normal-Dot and Micro-Dot) to adjust the right head CW
printing delay (position and time) and the left head CCW printing delay (position and time) in the firmware.
AJST: UniDirPrint
Head Gap: -34765
µ
m
Press [ENTER]
after correction
Setting can be specified in units of 5
µ
m
Press [ENTER] to update gap
ENTER
ENTER
Adjustment Print
Displayed during printing
DIAG: Adjustment
Panel
CW Adjustment for Normal-Dot
Set values are updated by [ENTER]. In the case where [ENTER] was pressed
under "Head Gap:", if the parameter change is changed another adjustment print
will be made.
If [ENTER] is pressed without the parameter being changed, control shifts to
"Adjust: CW (MD)".
AJST: UniDir (MD)
Head Gap: -34765
µ
m
Press [ENTER]
after correction
Setting can be specified in units of
±
5
µ
m
Press [ENTER] to update gap
Adjustment Print
ENTER
ENTER
Displayed during printing
DIAG: AJST
Panel
CW Adjustment for Micro-Dot
Set values are updated by [ENTER]. In the case where [ENTER] was pressed
under "Head Gap:", if the parameter change is changed another adjustment print
will be made.
If [ENTER] is pressed without the parameter being changed, control shifts to "Flush
Pointer adjustment".
→
Continued on next page