R E P 1 3 9 1
Model Name: Rockhopper-46/62
R E P 1 3 9 1
Model Name: Rockhopper-46/62
How to replace the Head and Head Cable
How to replace the Head and Head Cable
Item
Replacement and Adjustment Procedure
2. Assembling
1. For bending, refer to the head cable that was previously used.
CAUTION: The bend on the print head side of the head cable used with Head 1
(left) should be made such that the protrusion from the connector is
minimal. Otherwise the range for adjusting head inclination becomes
too small and adjustment is impossible.
2. Print the head rank of the print head that is to be used on the head cable. If the previous
head rank is inscribed, this should be cancelled with two lines before the print.
3. Assembly is the reverse of dismantling.
CAUTION: The parts inside the print head that are shown in diagram A must not
be touched. Otherwise oil and dirt may make it impossible for them to
be used properly.
[Diagram A]
Damper connection
Nozzle face
→
Continued on next page
Correct
Example of head cable bending for Head 1 (left)
Wrong
