B A C 2 0 8 0
Model Name: Rockhopper-46/62
B A C 2 0 8 0
Model Name: Rockhopper-46/62
Adjustment: Repeatability Printing Position
Adjustment: Repeatability Printing Position
This procedure is used to align left and right Normal-Dot and Micro-Dot repeatability printing positions. This involves making a bidirectional test print and from the results
adjusting the CCW printing delay (position and timing) by entering into the firware the differences between the CW printing position and the CCW printing position. There are
separate differences for both black and colour normal dots and micro dots.
KCG Err: -250
µ
m
Menu Up
MYO Err: -250
µ
m
Adjustment Print
AJST: BiDirPrint
DIAG: Adjustment
Bidirectional position adjustment for Normal-Dot
Displayed during printing
Setting can be specified in units of
10
µ
m using the VALUE + and - keys
Press [ENTER] to update reciprocal difference
Setting can be specified in units of
10
µ
m using the VALUE + and - keys
Press [ENTER] to update the reciprocal difference
Print Start?
Press [ENTER]
without correction
Menu Down
ENTER
ENTER
Press [ENTER]
after correction
ENTER
If [ENTER] is pressed at “MYO Err:” and the parameter has been changed,
the left and right CCW printing delays (position and timing) will each be updated
in the firmware and another adjustment print will be made.
If the parameter was not changed, “Print Start?” will be displayed.
If [ENTER] is pressed, another adjustment print will be made.
If [Back] is pressed, the display will move to “AJST: BiDir (MD)”.
KCG Err: -250
µ
m
Menu Up
ENTER
ENTER
MYO Err: -250
µ
m
Adjustment Print
AJST: BiDir (MD)
DIAG: Adjustment
Bidirectional position adjustment for Micro -Dot
Displayed during printing
Setting can be specified in units of
10
µ
m using the VALUE + and - keys
Press [ENTER] to update reciprocal difference
Setting can be specified in units of
10
µ
m using the VALUE + and - keys
Press [ENTER] to update the reciprocal
difference
Print Start?
Press [ENTER]
without correction
Menu Down
Press [ENTER]
after correction
ENTER
If [ENTER] is pressed at “MYO Err:” and the parameter has been changed,
the left and right CCW printing delays (position and timing) will each be updated
in the firmware and another adjustment print will be made.
If the parameter was not changed, “Print Start?” will be displayed.
If [ENTER] is pressed, another print will be made.
If [Back] is pressed, the display will move to “AJST: UniDirPrint”. (BAC2090)
→
Continued next page