R E P 1 2 6 0
Model Name: Rockhopper-46/62
R E P 1 2 6 0
Model Name: Rockhopper-46/62
How to replace the Pump Assembly
How to replace the Pump Assembly
Item
Replacement and Adjustment Procedure
1. Replacement
Procedure
2. Adjustment and
Examination
Procedure
« REFERENCE » When the pump assembly is replaced, the wiper
should also be replaced at the same time so be
sure to have a spare wiper ready.
Replace the Pump Assembly
1.
Remove the Panel Cover.
2.
Remove the Front Cover.
3.
Remove the Y Rail Cover.
4.
Remove the Panel Bottom Cover.
5.
Remove the Panel Mounting Plate.
6.
Take out the Maintenance Station Assembly.
7.
Disconnect and remove the tubes between the Pump Assembly and the
Cap Assembly.
8.
Remove the waste liquid tube that is clamped to the outside of the
Right Frame.
9.
Remove the metal plate to which the gear is attached together with two
screws.
10.
Remove the pump assembly (1 screw), slide it towards the wiper and
lift it out.
11.
Assembling is the reverse of the removal procedure.
« REFERENCE » Before assembly, check that the wiper is installed
on the pump assembly.
1. Carry out the Capping Position Adjustment.
2. Initialize the wiper count.
CAUTION:
Be sure to clamp the waste liquid tube in the
proper position on the outside of the right frame.
Otherwise the ink will spill and soil the floor and
clothing.
CAUTION:
When you insert the tubes into the cap assembly
refer to the picture on the right so that the tubes
do not exert any load.
Otherwise the cap assembly will not move smoothly.
