Mitsubishi Electric Melservo MR-J3-100B, Руководство пользователя

Страница: 333 / 590

Part 6: Common Reference Material
6 - 56
2.2.5 Conversion rules (MR-J3-_A_ => MR-J4-_A_)
The following table shows the servo parameter conversion rules from MR-J3-_A_ to MR-J4- _B_.
Servo parameters not specified in the following table will be set to the initial values.
POINT
Because the servo parameters of MR-J3-_A _ and those of MR-J4-_A_ are not
completely interchangeable, the conversion rules may not be applied. Check the
operations and review the settings as necessary.
The value of the parameter writing after parameter conversion is the initial value.
• MR-J4-_A_: [Pr. PA19] = "00AAh"
Various offset parameters cannot be converted. Change the settings as
necessary.
• MR-J4-_A_: [Pr. PC37] to [Pr. PC40]
The following parameters of MR-J4-_A_ are compatible with the servo
amplifier's software version A3 or later. The software version can be checked in
the system configuration.
• MR-J4-_A_: [Pr. PA03 Absolute position detection system "_ _ _2h" (Absolute
position detection system by communication)]
• MR-J4-_A_: [Pr. PC21 RS-422 communication function selection]
When the geared servo motor is replaced, the reduction ratio may differ before
and after the replacement. Check the specifications of the servo motor and
review the electronic gear settings as necessary.
• MR-J4-_A_: [Pr. PA05] to [Pr. PA07]
MR-J3-_A_ MR-J4-_A_
Conversion rule
No. Name Type Target No.
Type Target
PA01 Control mode Hex _ _ _ X PA01 Hex _ _ _ X The setting value will be maintained.
PA02 regenerative option Hex _ _ XX PA02 Hex _ _ XX The setting value will be maintained.
PA03 Absolute position detection system Hex _ _ _ X PA03 Hex _ _ _ X
01_ _ will be changed to _ _ 01.
02_ _ will be changed to _ _ 02.
Otherwise, _ _ 00 will be set.
PA04 Function selection A-1 Hex _ _ _ X PD24 Hex _ _ XX
01_ _ will be changed to _ _ 05.
(MBR)
The setting value other than above
will not be maintained.
PA05
Number of command input pulses
per revolution
Dec -
PA05 Dec -
0 will be changed to 10000.
Otherwise, the setting value will be
maintained.
PA21 Hex X_ _ _
0 will be changed to 2_ _ _.
Otherwise, 1_ _ _ will be set.
PA06
Electronic gear numerator
(Command pulse multiplying factor
numerator)
Dec - PA06 Dec - The setting value will be maintained.
PA07
Electronic gear denominator
(Command pulse multiplying factor
denominator)
Dec - PA07 Dec - The setting value will be maintained.
PA08 Auto tuning mode Hex _ _ _ X PA08 Hex _ _ _ X The setting value will be maintained.
PA09 Auto tuning response Dec - PA09 Dec -
The value 4 is added to the setting
value.
PA10 In-position range Dec - PA10 Dec - The setting value will be maintained.
PA11 Forward rotation torque limit Dec - PA11 Dec - The setting value will be maintained.
PA12 Reverse rotation torque limit Dec - PA12 Dec - The setting value will be maintained.
PA13 Command pulse input form Hex _ _ XX PA13 Hex _ _ XX The setting value will be maintained.
PA14 Rotation direction selection Dec - PA14 Dec - The setting value will be maintained.
Hex: hexadecimal parameter; Dec: decimal parameter