Mitsubishi Electric FR-F700PJ Series, Инструкция по эксплуатации

Страница: 214 / 356

209
Selection of operation mode and operation location
4
P
ARAM
ETE
R
S
4.19.2 Setting the frequency by the operation panel
POINT
 Use the operation panel to give a start command and a frequency command. (PU operation)
Operation
example
Operate at 30Hz.
Operation Display
1.
Screen at power-ON
The monitor display appears.
2.
Change the Pr. 79 setting to "1".
( Refer to page 60 for change of the setting.)
3.
Turn to show the frequency you want to
set.
The frequency flickers for about 5s.
4.
While the value is flickering, press to set the
frequency. After about 3s of flickering, the
indication of the value goes back to " "
(monitor display).
(If is not pressed, the indication of the
value goes back to " " (0.00Hz) after
about 5s of flickering. In that case, go back to
"operation step 3" and set the frequency again.)
Flicker...frequency setting complete!!
The monitor display appears after 3s.
5.
Start  acceleration  constant speed
Press to start operation.
The frequency value on the indication
increases in
Pr. 7 Acceleration time, and
" " (30.00Hz) appears.
6.
To change the set frequency, perform the operation in above steps 3 and 4. (Starting from the previously set frequency.)
7.
Deceleration  stop
Press to stop.
The frequency value on the indication
decreases in
Pr. 8 Deceleration time, and the
motor stops rotating with " " (0.00Hz)
displayed.
Operation panel
Flickers for about 5s
Stop