LS ELECTRIC L7NHF Series, Руководство пользователя

Страница: 387 / 409

13. Test Drive
13-7

Verify if the state displayed at the bottom-right of the TwinCAT System
Manager menu window is in the Run state.
11
We have finished adding NC-Task and I/O Devices (servo drive) to the
TwinCAT System Manager.

Setting NC-Task Axis Parameters
Order Handling Notes
1
Set the display units for the relevant axis.

Select Axis1.

Click the Settings tab.

Click the display units for position and speed.
Note: Remember the actual units will not be converted even if the units shown
in the figure above was converted to mm or degrees.
Note: Change the units and tune the Axis Scaling Factor below.
2
Set the Axis Scaling Factor. The Axis Scaling Factor determines the distance of
the axial load movement while the motor shaft makes one revolution.

Select Axis1.

Select the Parameter tab.

Set the Scaling Factor.

Then, download the settings.