Kyocera Mita DC-1560, Руководство по обслуживанию

Страница: 181 / 289

1AF
3-3-25
6. Run the end with the spring through the scanner wire holder on light source unit 1.
................................................................................................................................
5
7. Loop that end of the wire around the inner groove in the scanner wire pulley on light
source unit 2 from bottom to top. ............................................................................
6
8. Hook the wire spring to its holder on the left side of the machine. .........................
7
9. Loop the end with the round terminal around the scanner wire pulley on the right side
of the machine from bottom to top. .........................................................................
8
10. Loop that end of the wire around the outer groove in the scanner wire pulley on light
source unit 2 from bottom to top. ............................................................................
9
11. Hook the round terminal to its holder on the right side of the machine. .................
0
12. Repeat steps 2 to 11 on the machine front.
Outside
Inside
Wire holder Scanner wire drum clip
Figure 3-3-29 Installing a scanner wire
13. Remove the scanner wire drum clips.
14. Move light source unit 2 all the way toward the right. .............................................
!
15. Move light source unit 1 all the way toward the right until it is stopped by unit 2. ..
@
16. Fasten the scanner wires to light source unit 1 with the wire retainers. .................
#
Screw
Wire retainer
Light source unit 1
Light source unit 2
Figure 3-3-30 Fastening a scanner wire