Korg NAUTILUS Series, Руководство по параметрам, Страница: 472 / 961

SEQUENCER mode
462
• Copy From Song → p.522
• Load Template Song → p.522
• Save Template Song → p.523
• FF/REW Speed → p.523
• Set Location (for Locate Key) → p.523
• GM Initialize → p.523
• Copy from Combi → p.525
• Copy From Program → p.525
• Copy Scene → p.121
• Swap Scene → p.122
• Add To Set List → p.113
• Initialize Scene → p.122
• PAGE → p.126
• MODE → p.126
0–8: Sampling
Here you can adjust the settings for the analog/digital audio
signal input (AUDIO INPUT, USB), and the sampling-
related settings for SEQUENCER mode.
In SEQUENCER mode, the external audio sources you
specify here can be recorded to audio tracks or sampled.
(You can also record or sample a song that’s played back by
the NAUTILUS or your own playing on the keyboard.) You
can also use the NAUTILUS as a 4-in/6-out effect processor.
You can’t record a Song or pattern while sampling. Nor
can you sample while recording a Song or pattern.
0–8a: Sampling Setup
Here you can select the source to be sampled, and the
method by which to initiate sampling.
Except for Trigger , the following parameters are the same as
in the PROGRAM > Home– Sampling - Sampling Setup
page. For more information, see “0–8a: Sampling Setup” on
page 22.
Sampling Setup settings are maintained not separately for
each song, but as a single set in SEQUENCER mode.
Source Bus [Audio Input1/2, USB 1/2, L/R, REC1/2,
REC3/4, Indiv.1/2, Indiv.3/4]
Source Direct Solo [Off, On]
Sample to Disk [16-bit, 24-bit]
Save to [RAM, Disk]
Sample Mode [L-Mono, R-Mono, Stereo]
Sample Time [min] [sec]
Trigger [Sampling START button, Note On,
Threshold, Sequencer START button]
Specifies how sampling will be initiated.
0–8c
0–1a
0–8PMC
0–8a
0–8b