Korg NAUTILUS Series, Руководство по параметрам, Страница: 676 / 961

GLOBAL mode
666
Intensity [–63…+63]
This controls the depth and direction of the Position
modulation. Negative modulation moves the position earlier
in the sequence, to the limit of Step 1. Positive modulation
moves the position later in the sequence, to the limit of the
End Step.
Position modulation and loops
Position AMS affects only the current step, and does not
change the loop start or loop end. This means that Position
AMS can make the Wave Sequence jump into the middle of
the loop, or jump back out of the loop again.
Duration
AMS [List of AMS Sources]
This selects a modulation source to control the step duration
and crossfade times. You can speed up or slow down the
Wave Sequence so that it runs between 1% and 400% of the
original rate. This can be very useful for making a cross-
faded Wave Sequence sound more organic.
For a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [1…400%]
This controls the amount of Duration modulation.
1% means that, at the maximum AMS value, step durations
and crossfade times will be 100 times shorter than their
programmed settings.
400% means that, at the maximum AMS value, step
durations and crossfade times will be four times longer than
their programmed settings.
Put another way, values 99% and lower make the Wave
Sequence go faster, and values 101% and higher make it go
slower.
v 4–1: Page Menu Commands
• Compare → p.112
• Write Wave Sequence → p.690
• PAGE → p.126
• MODE → p.126
4–2: Step Parameter
4–2a: Basic
Wave Sequence [A000...A149, B00...O31]
This is the bank, number, and name of the current Wave
Sequence. For more information, please see “Wave
Sequence,” on page 662.
Mode [Time, Tempo]
This switches between Time mode (for evolving, crossfaded
Wave Sequences) and Tempo mode (for rhythmic Wave
Sequences). For more information, please see “Mode,” on
page 662.
= (Tempo) [040.00…300.00, EXT]
This is the current system tempo. For more information,
please see “Tempo” on page 663.
Run [Off, On]
This determines whether or not the Wave Sequence will
move through its steps automatically. For more information,
please see “Run,” on page 663.
Key Sync [Off, On]
This determines whether each note will play its Wave
Sequence separately (
Key Sync On ), or whether all of the
notes will play together ( Key Sync Off ). For more
information, please see “Key Sync,” on page 663.
4–2PMC
4–2a
4–2b
4–2c
4–2d