Korg NAUTILUS Series, Руководство по параметрам, Страница: 540 / 961

SEQUENCER mode
530
If you selected In-Track Sampling:
1. Refer to Auto HDR/Sampling Setup steps 1 and 2, and
select In-Track Sampling.
2. Use “Source Audio” to select the external audio input
source: analog Audio Input 1/2 or USB.
3. Use “Mono-L/Mono-R/Stereo” to select the input
source and the number of channels you will sample.
Mono-L uses Analog 1 or USB 1.
Mono-R uses Analog 2 or USB 2.
Stereo uses both channels from the given input.
4. Use the “To” field to select the track that you will use
for In-Track Sampling.
Note data will automatically be written to the track you
select.
5. Use “Program” to specify the program into which the
sample will be converted.
When sampling ends, the entire process of creating a new
multisample through converting it to a program and
assigning it to a track will be performed automatically.
6. Press the OK button to execute the command. If you
decide not to execute, press the Cancel button.
For more information, see “Auto HDR/Sampling Setup:
Automatically-set parameters and their values” on
page 531.
In-Track Sampling after you execute this
command
1. Use “Location” to specify the location from which you
want the song to play back.
2. Press the SAMPLING REC button to enter sampling-
standby mode.
3. Press the SEQUENCER START/STOP button to
begin playback.
4. At the point where you want to start sampling, press
the SAMPLING START/STOP button. In-Track
Sampling will begin.
5. Play the instrument etc. that is connected to the
AUDIO INPUT jack you selected as the “Source
Audio” setting.
6. When you’re finished playing, press the SAMPLING
START/STOP button to stop only sampling.
If you press the SEQUENCER START/STOP button,
both sampling and song playback will stop.
Note: If you continue sampling after executing In-Track
Sampling, successive samples will automatically be
assigned to C#2, D2, … etc. However if you execute
Auto Sampling Setup once again and then sample, the
samples will be created in a new multisample.
Auditioning the data you sampled
• Return the “Location,” and then press the SEQUENCER
START/STOP button to play back the song.
Alternatively, use
Track Select (0–1a) to select the track
you specified in “To” (dialog box), and play the C2 key.
An example of changing the settings
• If you want to apply an insert effect to the input source,
go to the SEQUENCER > Home– Sampling page and set
Audio Input
Bus Select to IFX1–IFX12. Set the Bus
Select following the insert effect you’re using to REC
1/2.
• To change the way in which sampling is initiated, change
the “Trigger” setting. If you set this to Threshold,
resampling will begin the instant the input level exceeds
the specified value.
Use the page menu command
Select Sample No. to
select the sampling-destination RAM memory.