JPS IRIS-IMSV, Руководство пользователя

Страница: 33 / 106

www.jps.com.tw
32
THERMISTOR adjust Group <Refer to Chapter-10.12>
No. Name Default Min. Max. Unit Type GXX-XX
140 Heat sink temperature ( degC) 0 0 250 degC M 83-00
150 OVER-Temperature Protect LEVEL 80 50 100 degree R/W 83-01
FAN adjust Group <Refer to Chapter-10.13>
No. Name Default Min. Max. Unit Type GXX-XX
146 FAN control type 0 0 1 -- R/W 84-00
148 FAN measure Speed 0 0 65535 rpm M 84-02
149 FAN Speed Warning/Trip Level 2000 0 30000 rpm R/W 84-03
9.2 Monitor Type Parameters’ Address
The table showed below list the Monitor type parameters, and there address. User can read it by communication.
Name Unit Address (Pr.)
Driver’s output voltage V 013
Motor’s actual speed rpm 019
Driver’s output frequency Hz 030
Alarm message -- 035
Driver’s output current rms(Amp) 213
9.3Parameter’s Type
The table showed below describing the different type of all the parameter of this manual:
Type Description
R/W
The parameter is Readable and Writable, and can be stored in EAROM.
All this type parameters can be initialized by the Pr.369 function.
FR/W
The parameter is Readable and Writable, and can be stored in EAROM.
This type of parameter is specially set by Factory and not for user normally usage.
This type of parameter only can be modified by authorized person.
RAM
The parameter is Readable and Writable, but it uses the RAM to temporally store the
change of parameter. After power on or reset it will be recover to be default value.
M The parameter is Monitor type. Only readable and no effect for writing this parameter.
F Factory set parameter, and should not be changed.
R
To indicate that any change of this type of parameter have to Reset the driver to enable
the change.