JPS IRIS-IMSV, Руководство пользователя

Страница: 61 / 106

www.jps.com.tw
60
z
DIx _ Select
Î
0, No function
When select number, the output will be OFF all the time.
z
DIx _ Select
Î
6, Over Heat Protect (OH)
The input terminal can accept external A type output thermo-relay signal to let driver to
trip and show OH alarm message.
z
DIx _ Select
Î
7, Negative Output of Over Heat Protect (/OH)
The input terminal can accept external B type output thermo-relay to let driver to trip
and show OH alarm message.
z
DIx _ Select
Î
10, Speed Select SW0
z
DIx _ Select
Î
11, Speed Select SW1
z
DIx _ Select
Î
12, Speed Select SW2
These 3 functions are used to select the pre-set speed Pr.270 ~ Pr.277. To use the 8 sets
pre set speed function, the Pr.278 must set to be 0.
Usage of SW0 ~ SW2:
Parameter
Selected
Speed
SW2
DIx(12)
SW1
DIx(11)
SW0
DIx(10)
NOTE
120 Speed Set0 0 0 0
121 Speed Set1 0 0 1
122 Speed Set2 0 1 0
123 Speed Set3 0 1 1
124 Speed Set4 1 0 0
125 Speed Set5 1 0 1
126 Speed Set6 1 1 0
127 Speed Set7 1 1 1
0：DI non active
1：DI active
z
DIx _ Select
Î
13, Speed Command Setting Select
If the input is active, the speed command is set from AI1.
If the input is non active, the speed command is set from digital (Speed Set0 ~ 7).
z
DIx _ Select
Î
21, Run / Stop Enable Switch
If the input is active, the Run / Stop function is enabled.
If the input is non active, the Run / Stop function is disabled.
【NOTE】This function is same with the Pr.059 function, please refer to Pr.059 for detail.
The priority of these two function is: DIx(21) > Pr.059.
z
DIx _ Select
Î
23, Reset
If the input is active, the driver will be reset by this signal.
【NOTE】This function only can be selected only by actual terminal, for virtual terminal
can not select this function.