Hitachi WJ200-001L, Инструкция по эксплуатации, Страница: 478 / 680

Ver.2

49
Standard Functions
NOTE:. Mark “

” in A line of [ Run Mode Edit] shows the accessible parameters when b031 is not set “10”,
high level access.
NOTE:. Mark “

” in B line of [ Run Mode Edit] shows the accessible parameters when b031 is set “10”,
high level access
“A” Function
Run
Mode
Edit
Defaults
Func.
Code
Name Description A B Initial data Units

Frequency source Eight options; select codes:

 POT on ext. operator

 Control terminal

 Function F001 setting

 Modbus network input


Option

 Pulse train input

 via EzSQ

 Calculate function output
  01



Frequency source,
2
nd motor
  01



Run command source Four options; select codes:

 Control terminal

 Run key on keypad,
or digital operator

 Modbus network input

 Option
  01



Run command source,
2
nd motor
  01



Base frequency Settable from 30 Hz to the maximum
frequency(

)
  50.0 Hz

Base frequency,
2
nd motor
Settable from 30 Hz to the 2
nd
maximum
frequency(

)
  50.0 Hz

Maximum frequency Settable from the base
frequency to 400 Hz
  50.0 Hz

Maximum frequency,
2
nd motor
Settable from the 2 nd base
frequency to 400 Hz
  50.0 Hz

[AT] selection Three options; select codes:

...Select between [O] and [OI] at [AT]
(ON=OI, OFF=O)

...Select between [O] and external POT
at [AT]
(ON=POT, OFF=O)

...Select between [OI] and external
POT at [AT]
(ON=POT, OFF=OI)
  00
 

[O] input active range start
frequency The output frequency corresponding to
the analog input range starting point,
range is 0.00 to 400.0
  0.00 Hz

[O] input active range end
frequency The output frequency corresponding to
the analog input range ending point,
range is 0.0 to 400.0
  0.00 Hz

[O] input active range start
voltage The starting point (offset) for the active
analog input range,
range is 0. to 100.
  0. %

[O] input active range end
voltage The ending point (offset) for the active
analog input range,
range is 0. to 100.


100. %

[O] input start frequency
enable Two options; select codes:

 Use offset (

value)

 Use 0Hz


01

