Hitachi WJ200-001L, Инструкция по эксплуатации

Страница: 148 / 680

3

63
“b” Function Run
Mode
Edit
Defaults
Func.
Code
Name Description Initial data Units

Torque limit selection Three option codes:


Quadrant-specific setting
mode

 Terminal-switching mode

 Analog voltage input mode(O)

00 

Torque limit 1 (fwd/power) Torque limit level in forward
powering quadrant, range is 0 to
200%/no(disabled)

200 %

Overload restriction level Sets the level of overload
restriction, between 20% and
200% of the rated current of the
inverter, setting resolution is 1% of
rated current

Rated
current
x 1.5
Amps

Torque limit 3 (rev/power) Torque limit level in reverse
powering quadrant, range is 0 to
200%/no(disabled)

200 %

Torque limit 4 (fwd/regen.) Torque limit level in forward
regen. quadrant, range is 0 to
200%/no(disabled)

200 %

Torque LAD STOP
selection Two option codes:


 Disable

 Enable

00

When “

” is specified for the torque
limit selection (

), the torque limits 1
to 4 apply as shown to the top right.
When “

” is specified for the torque
limit selection (

), the torque limit 1
to 4 are set as shown to the bottom right.
The torque limit 1 to 4 are switched by
the torque limit switches 1 and 2
assigned to intelligent input terminals 7
and 8, respectively for example:
When applying the torque limit function
to the motor operation at low speed, also
use the overload restriction function to
get more stable performance.
Related parameters: Over torque / under torque signal
Forward rotation
Reverse rotation
Regeneration
(

)
Torque
(+)
Torque
(-)
Powering
(

)
Powering
(

)
Regeneration
(

)
41 42
CM1
7 6
OFF OFF


ON OFF
 
OFF ON


ON ON
 