Hitachi WJ200-001L, Инструкция по эксплуатации, Страница: 172 / 680

3

87
Input Function Summary Table
Option
Code
Terminal
Symbol
Function Name Description
 BOK Brake confirmation ON
Brake wait time (

) is valid
OFF Brake wait time (

) is not valid

LAC LAD cancellation ON Set ramp times are ignored. Inverter output
immediately follows the freq. command.
OFF Accel. and/or decel. is according to the set ramp time
 PCLR Pulse counter clear ON Clear the position deviation data
OFF Maintain the position deviation data

ADD ADD frequency enable ON
Adds the

(add frequency) value to the output
frequency
OFF Does not add the

value to the output frequency

F-TM Force Terminal Mode ON Force inverter to use input terminals for output
frequency and Run command sources
OFF Source of output frequency set by

and source of
Run command set by

is used
 ATR Enable torque
command input ON Torque control command input is enabled
OFF Torque control command input is disabled

KHC Clear watt-hour data ON Clear watt-hour data
OFF No action
 MI1 General purpose input
(1) ON General purpose input (1) is made ON under EzSQ
OFF General purpose input (1) is made OFF under EzSQ

MI2 General purpose input
(2) ON General purpose input (2) is made ON under EzSQ
OFF General purpose input (2) is made OFF under EzSQ
 MI3 General purpose input
(3) ON General purpose input (3) is made ON under EzSQ
OFF General purpose input (3) is made OFF under EzSQ

MI4 General purpose input
(4) ON General purpose input (4) is made ON under EzSQ
OFF General purpose input (4) is made OFF under EzSQ
 MI5 General purpose input
(5) ON General purpose input (5) is made ON under EzSQ
OFF General purpose input (5) is made OFF under EzSQ

MI6 General purpose input
(6) ON General purpose input (6) is made ON under EzSQ
OFF General purpose input (6) is made OFF under EzSQ
 MI7 General purpose input
(7) ON General purpose input (7) is made ON under EzSQ
OFF General purpose input (7) is made OFF under EzSQ

AHD Analog command hold ON Analog command is held
OFF Analog command is not held

CP1 Multistage-position
switch (1) ON Multistage position commands are set according to
the combination of these switches.
OFF

CP2 Multistage-position
switch (2) ON
OFF

CP3 Multistage-position
switch (3) ON
OFF

ORL Limit signal of homing ON Limit signal of homing is ON
OFF Limit signal of homing is OFF

ORG Trigger signal of
homing ON Starts homing operation
OFF No action
 SPD Speed/position
changeover ON Speed control mode
OFF Position control mode