Hioki IM3536, Инструкция по эксплуатации

Страница: 31 / 270

27
Screen Layout and Operation
The following information can be displayed:
Display Description Remarks
FREQ Measurement frequency
For AC and DC
RANGE Measurement range
LOW Z Low Z high accuracy mode
*1
J SYNC
JUDGE synchronization setting for the
measurement range
SPEED Measurement speed
AVG Average
V Measurement signal level
AC: Setting
DC: Fixed to 1.00 V
DELAY Trigger delay
Used for both AC and DC.
(Displayed for
INFO AC
only)
SYNC Trigger synchronous output
JUDGE Measurement result judgment
OPEN Open correction
SHORT Short correction
LOAD Load correction
CABLE Cable correction
SCALE Scale correction (Correlation Correction)
LIMIT Limit
AC only
DC BIAS DC bias
L FREQ Line frequency
DC only
DCR OFFSET DC adjustment value acquisition time *2
DC DELAY DC delay
ADJ DELAY Adjustment delay
*1: When set to ON, the display will show ON * if set to a measurement range or measurement frequency for
which the output resistance will be 100
Ω
.(See “Low Z High Accuracy Mode” (p. 56))
*2: The acquisition time will not be displayed if DC adjustment is ON. When DC adjustment is OFF, the display
will show RESERVED after DC offset acquisition, and the acquisition time will be displayed once acquisition
is complete.
Configuring correction functionality ( ADJ screen)
This screen is used to configure correction functionality (LCR mode only).
1
Touch the ADJ key.
2
Touch the key for the parameter you
wish to set.
The settings screen for the parameter will
be displayed.
3
Configure the settings.
See “5 Error Correction” (p. 97).
1
Overview