Hioki BT5525, Инструкция по эксплуатации, Страница: 51 / 215

51
Display during a Test
4.2 Display during a Test
The test voltage is applied to the DUT from the instrument during the test.
If the test time is set to [ON]
See “3.5 Setting the Test Time and Comparator Delay Time” (p. 40).
When the
START key is pressed, the test voltage is applied to the DUT and the timer starts
counting down.
The remaining time is displayed in the test time display area (TIMER).
[D] is displayed at the left side of the countdown time during comparator delay.
The display during comparator delay is the same whether the comparator delay time is set to [AUTO]
or [MANUAL] .
Resistance measurement is performed until the set timer time and then the measured value is
displayed. (The unit is M
Ω
.)
When the comparator function is selected, a judgment is made according to the test mode setting.
(p. 44)
If the test time is set to [OFF]
See “3.5 Setting the Test Time and Comparator Delay Time” (p. 40).
When the
START key is pressed, the test voltage is applied to the DUT and the timer starts
counting up.
The elapsed time after the
START key was pressed is displayed in the test time display area
(TIMER).
[D] is displayed at the left side of the countup time during comparator delay.
The display during comparator delay is the same whether the comparator delay time is set to [AUTO]
or [MANUAL] .
Resistance measurement is performed until STOP is pressed and the measured value is displayed.
(The unit is M
Ω
.)
The elapsed time display is stopped when the timer counts up to 999.9 s, however, the resistance
measurement is performed until the
STOP key is pressed.
When the comparator function is selected, a judgment is made according to the test mode setting.
(p. 44)
Test Method
HIOKI BT5525A961-00