Chapter IV Function Parameter Table
60
Parameter
Code
Parameter
name
Parameter detailed description
Minimum
Unit
Factory
value
Change
1: Two-wire control mode 2: This mode
uses the defined FWD as the running
terminal and the direction is determined
by the defined REV terminal.
2: Three-wire control mode 1: This mode
uses the defined Sin as the enable
terminal, the run command is generated
by FWD or REV, and both also motor
direction. When the drive operates, the
terminal Sin must be closed. The terminal
FWD or REV needs a rising edge signal
to control the operation and direction of
the drive. When the drive stops, the
terminal Sin must be disconnected to
complete the stop.
3: Three-wire control mode 2: This mode
uses the defined Sin as the enable
terminal, the run command is generated
by FWD, and the direction is controlled
by REV. When the drive operates, the
terminal Sin must be closed. The FWD
terminal needs a rising edge signal to start