Chapter III Operation Instructions of Drive
33
Shortcut
parameter 1
Determined by function code
FC.17
Shortcut
parameter 2
Output current
Shortcut
parameter 3
Bus voltage
Shortcut
parameter 4
Set frequency
Shortcut
parameter 5
AI1
Shortcut
parameter 6
Terminal state 1
The above is the shortcut display in the general mode, which will vary with different industry
characteristics in other industry selections.
3.2.2 Settings of function code parameters
The function parameter system of this drive includes function code F0
～
FF group, monitoring
parameter U0 group, and fault record parameter U1 group. Each function group includes several
function codes. The function code is identified by (function code group function code
number). For example, “F5.08” indicates the 8th function code of the 5th function group.
Function code setting example:
Example 1: Change the forward jog frequency setting from 5Hz to 10Hz (F2.20 changed from
5.00Hz to 10.00Hz)
1) Press the PRG key to enter the programming state, the digital tube displays function
parameter “-
F0
-”, and press the ▲ key to make the LED digital tube display “-
F2
-”.
2) Press ENT, you can see the digital tube displays function parameter “
F2.00”.
3) Press the ▲ key to make the digital tube display function parameter “
F2.20
”.
4) Press the ENT key, you will see the data (5.00) corresponding to F2.20, meanwhile, the
LED (Hz) corresponding to its unit frequency lights up.
5) Press the
key, if flashes, shift to the highest bit “5”, and press the ▲ key five times, to
change to
10.00
.
6) Press the ENT key, if the parameter does not flash, it indicates the modification is
successful.
7) Press the PRG key, to exit the programming state.
Note: In P.off state, it is forbidden to modify the function code parameter.
3.2.3 Jog function operation
Use the keypad to perform the jog operation of the drive:
1) Press the PRG key three times to enter the jog operation state, and the digital tube displays
function parameter “
JOG-”.
2) Press and hold the Up key to forward and jog.
3) Press and hold the Down key to reverse and jog.