Chapter V Basic Operation Instructions
121
Set value
Function
Description
13
Set count value arrival
Refer to F6.22
～
F6.23 function description.
14
Specified count value
arrival
15
Set length arrival
When the actual length U0.15≥FC.11 set length, an indication
signal is output.
16
Drive ready to run
When this signal output is valid, it indicates that the drive has
no fault, the bus voltage is normal, and the drive operation
prohibition terminal is invalid. In this case, the start command
can be accepted.
17
Drive fault
If the drive fails, an indication is output.
18
Reserved
Reserved function.
19
Set cumulative
running time arrival
When the accumulated running time of the drive (U0.27)
reaches the running cutoff time (F0.02) of the drive, an
indication signal is output.
20
Forward running
The drive is under the forward running status and outputs an
indication signal.
21
Reverse running
The drive is under the reserve running status and outputs an
indication signal.
22
Reserved
Reserved function.
23
Water supply sleep
running indication
During water supply application, the drive is under the sleep
status and outputs an indication signal.
24
Water pipe
overpressure
indication
During water supply application, the drive judges that the
water pipe is overpressure at the time and outputs an indication
signal.
25
Water pipe
under-pressure
indication
During water supply application, the drive judges that the
water pipe is under-pressure at the time and outputs an
indication signal.
26
Water pipe shortage
indication
During water supply application, the drive judges that the
water pipe is short of water at the time and outputs an
indication signal.
27
Water tank shortage
indication
During water supply application, if the drive finds that the
water tank is in short of water at any time, it outputs an
indication signal.
28
Water pipe burst
indication
During water supply application, if the drive finds that the
water pipe burst at any time, it outputs an indication signal.
Related parameter table:
Parameter
Code
Parameter
name
Parameter detailed description
Minimum
Unit
Factory
value Change
F6.11
Open
collector
output
terminal
DO1
0: No output
1: Drive running signal (RUN)
2: Frequency arrival signal (FAR)
3: Frequency level detection signal (FDT1)
4: Frequency level detection signal (FDT2)
5: Overload detection signal(OL)
6: Undervoltage lockout stopping (LU)
7: External fault stop (EXT)
8: Frequency upper limit (FHL)
9: Frequency lower limit (FLL)
10: Drive running at zero frequency
11: PLC phase running completion
12: PLC cycle completion
13: Set count value arrival
14: Specified count value arrival
1
0
×
F6.12
1
1
×