Extreme Networks Altitude 4000 Series, Справочное руководство, Страница: 383 / 521

Fault Management
Altitude
TM
4000 Series Access Point System Reference Guide
383
3 Select the Add to Active Filters button to create a new filter and add it to the Active Event Filters table.
When added, the filter uses the configuration defined in the Customize Event Filters field.
4 Refer to the Active Event Filters table to set the following parameters:
a To activate all the events in the Active Events Filters table, select the Enable All Events button. To
stop event generation, select Disable All Events .
b To enable an event in the Active Event Filters table, click the event, then select the Activate Defined
Filter button.
NOTE
Filters cannot be persisted across sessions. They must be created every time a new session is
established.
5 Select View Events from the upper, left-hand, side of the Fault Management browser.
Use the View Events screen to track and troubleshoot events using source and severity levels defined
in the Configure events screen.
6 Refer to the following event parameters to assess nature and severity of the displayed event:
7 Select Clear All to clear the events displayed on this screen and begin a new event data collection.
Timestamp
Displays the timestamp (time zone specific) when the event occurred.
Module
Displays the module used to track the event. Events detected by other
modules are not tracked.
Message
Displays error or status messages for each event listed.
Severity
Displays the severity of the event as defined for tracking from the
Configuration screen. Severity options include:
All Severities – All events are displayed regardless of their severity
Critical – Only critical events are displayed
Error – Only errors are displayed
Warning – Only warnings are displayed
Informational – Only informational events are displayed
Source
Displays the MAC address of the source device tracked by the selected
module.