Extreme Networks Altitude 4000 Series, Справочное руководство, Страница: 210 / 521

Chapter 6: Device Configuration
Altitude
TM
4000 Series Access Point System Reference Guide
210
7 Refer to the Area Identifier field to define or override the Level 1 and Level 2 Area IDs used by the
profile’s MINT configuration.
8 Define or override the following Priority Adjustment settings:
9 Select the Latency of Routing Recalculation check box (within the Shortest Path First (SPF) field) to
enable the spinner control used for defining or overriding a latency period between 0 - 60 seconds.
The default setting has the check box disabled.
10 Define or override the following MINT Link Settings :
11 Select OK to save the changes and overrides made to the Settings tab. Select Reset to revert to the last
saved configuration.
12 Select the IP tab to display the link IP network address information shared by the devices managed
by the MINT configuration.
Level 1 Area ID Select the box to enable a spinner control for setting the Level 1 Area ID
between 1 - 4,294,967,295. The default value is disabled.
Designated IS Priority
Adjustment Use the spinner control to set a Designated IS Priority Adjustment setting
between -255 and 255. This is the value added to the base level DIS
priority to influence the Designated IS (DIS) election. A value of +1 or
greater increases DISiness. The default setting is 0.
MLCP IP Check this box to enable MINT Link Creation Protocol (MLCP) by IP
Address. MINT Link Creation Protocol is used to create one UDP/IP link
from the device to a neighbor. That neighboring device can be another
AP.
MLCP VLAN Check this box to enable MLCP by VLAN. MLCP is used to create one
VLAN link from the device to a neighbor. That neighboring device can be
another AP.