Extreme Networks Altitude 4000 Series, Справочное руководство, Страница: 212 / 521

Chapter 6: Device Configuration
Altitude
TM
4000 Series Access Point System Reference Guide
212
13 Set the following Link IP parameters to complete the MINT network address configuration:
14 Select the VLAN tab to display the link IP VLAN information shared by the access points managed
by the MINT configuration.
The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval and Adjacency
Hold Time managed devices use to securely communicate amongst one another.
IP Define or override the IP address used by peer access points for
interoperation when supporting the MINT protocol.
Routing Level Use the spinner control to define or override a routing level of either 1 or
2.
Listening Link Specify a listening link of either 0 or 1. UDP/IP links can be created by
configuring a matching pair of links, one on each end point. However, that
is error prone and doesn’t scale. So UDP/IP links can also listen (in the
TCP sense), and dynamically create connected UDP/IP links when
contacted.
Port To specify a custom port for MiNT links, check this box and use the
spinner control to define or override the port number between 1 and
65,535.
Forced Link Check this box to specify the MiNT link as a forced link. This setting is
disabled by default.
Link Cost Use the spinner control to define or override a link cost between 1 -
10,000. The default value is 100.
Hello Packet Interval Set or override an interval in either Seconds (1 - 120) or Minutes (1 - 2)
for the transmission of hello packets. The default interval is 15 seconds.
Adjacency Hold Time Set or override a hold time interval in either Seconds (2 - 600) or Minutes
(1 - 10) for the transmission of hello packets. The default interval is 46
seconds.